QPNP-MISC

QPNP-MISC provides a way to read the PMIC part number and revision.

Required properties:
- compatible : should be "qcom,qpnp-misc"
- reg : offset and length of the PMIC peripheral register map.

Optional properties:
- qcom,pwm-sel:			Select PWM source. Possible values:
				0: LOW
				1: PWM1_in
				2: PWM2_in
				3: PWM1_in & PWM2_in
- qcom,enable-gp-driver:	Enable the GP driver. Should only be specified
				if a non-zero PWM source is specified under
				"qcom,pwm-sel" property.

- qcom,support-twm-config	Enable configuration for TWM mode.

- qcom,twm-mode			The TWM mode which PMIC enters post power-off.
				Valid only if 'qcom,support-twm-config' is
				defined. If not specified, the default mode
				is 3.

Example:
	qcom,spmi@fc4c0000 {
		#address-cells = <1>;
		#size-cells = <0>;
		interrupt-controller;
		#interrupt-cells = <3>;

		qcom,pm8941@0 {
			spmi-slave-container;
			reg = <0x0>;
			#address-cells = <1>;
			#size-cells = <1>;

			qcom,misc@900 {
				compatible = "qcom,qpnp-misc";
				reg = <0x900 0x100>;
				qcom,pwm-sel = <2>;
				qcom,enable-gp-driver;
			};
		}
	};